PEUGEOT 308 GTi II INDUCTION KIT

 

We were the first to design and develop a performance induction kit for the Peugeot 208 GTi and 308 GTi that increases throttle response and sound.

 

During our extensive test and development program we ensured by using load dynos for over 8 hours that our kit delivers more power and torque on all the maps we could test

 

TMSR2 has been tested for over 70'000km on road and in competitive racing. TMSR3 improves airflow even more.

 

  • Increase turbo spool rates of up to 15%
  • Improved throttle response
  • Heightened induction sound

 

As an example from our load dyno testing program on a 208 Gti (Euro 6) previously remapped to a stage 1  showed once TMSR2 was fitted the max peak power average increase @6000rpm  +9.88hp, mid range peak power increase @3800rpm +19hp  and the peak torque increase @3000rpm +31.52nm,  although every setup and modification can be unique to each car. Please see our load dyno comparisons for further information on performance gains.

 

TMSR2 comes complete with Pipercross performance cone filter, a new larger upper airbox that has our performance enhancing design inside, a guide to fitting plus stickers. Its plug and play, requires 20-25 minutes to install.

 

If you're looking to enhance your stage 1 / 2 / 3 or 4 remap with more mods so to gain extra torque and power then look no further

 

*Please note this is a tuning product, service intervals on your car can be higher due to modifications and increased wear and tear on other parts may also be evident. It all depends on how much power your map is running. Please see our remap section for more information on such modifications.

 

*Photo is TMSR3